gaqwatches.blogg.se - Aeon labs z-stick gen5 usbport changes when disconnected

Note that I have to multisensors, just one attached. I have only a limited amount of time, because if I can't get it working I will send it back to the shop, but they only give 2 weeks for that. If I can do anything to help solving this issue let me know soon. I attached the log and and configurations, I hope this is enough to tell what is going on. I also tested it under Window with the openzwave that came with domoticz (3.1.974), and it showed the same results (although the Fibaro only stopped responding after I tried to change a setting of the Multisensor, not when I clicked its zwave button, if I remember correctly) Motion detection isn't working, but that is another issue (already posted). I do get temperature, humidity and light levels. When connected to a host controller (PC, Mac, Linux, Raspberry Pi, etc. By being able to remotely include/remove Z-Wave devices, this greatly simplifies Z-Wave network installation. It only sometimes works, just after it is connected, but most of the time it is not responding. Aeon Labs Aeotec Z-Stick Gen5 is a self-powered Z-Wave USB adapter with remote network creation capabilities (independent from external power and host microprocessor). Futhermore I cannot change any setting of the multisensor.

I touch the zwave button on the multisensor device, or I try to change a setting and the Fibaro doesn't work anymore.

Now I attach a Aeon Labs Multisensor (Gen5) to power (USB), and it is still fine.

I can change settings, and it's stable.

I have a fibaro FGS221 Double Relay Switch 2x1.5kW running fine.

I have a zwave-me usb stick on a raspberry pi 2 running domoticz and openzwave 1.3.95.